We built our house in 1999 and the lighting is 100% X10 controlled. I just purchased a Paradigm processor and touch screen from the garage sale. I am planning on mounting the touch screen in the wall in our great room to mainly control new DMX LED RGB flood lights I am building to light our porch and yard trees and control these via paradigm. I have a X10 CM11 RS-232 interface. I was wondering if anybody has written a driver to have X10 talk to Paradigm. I looked up the X10 CM11 command set and it does not look to bad but why re-invent the wheel if this has allready be done......
KEN
