Hi Greg,

The end date for Windows 10 upgrades is coming up soon. Is the official ETC stance still to hold at 7/8.1?

Windows 10 Testing Update

We frequently receive inquiries about ETC software and Windows 10 compatibility.

On the whole, Windows 10 has not introduced new compatibility concerns over Windows 8 or Windows 7.

We have tested the following software packages, and will continue testing the remaining software in the near future.

Compatible:

• Eos ETCnomad v2.3.1 and higher
• Net3 Concert v1.1.1 and higher
• Smartsoft v3.0.2 (see below)
• Gateway Configuration Editor (GCE) v3.1.3
• Network Configuration Editor (NCE) v4.3.1
• DimStat v3.4.1
• Expression Offline v3.1.1 (and Personality Edit v1.2)
• Paradigm (LD, CD, VTS) v2.1.2 and higher

We have found the following incompatibilities:

• Smartsoft v3.0.2 does not include signed drivers, which can cause installation issues on some systems. Install the ETCNomad Gadget Driver Installer (http://www.etcconnect.com/WorkArea/DownloadAsset.aspx?id=10737484980) and the Smartfade should now connect to Smartsoft.
• The CEM+ web interface (Sensor+ Connect) is not compatible with Internet Explorer (IE) 11 or Microsoft’s new browser, Edge. Use IE11 in compatibility mode and chose IE10 or lower.
• Unison Light Manager does not run on 64-bit systems.