Hi, i've already asked the same by online and got some hope... I have Mosaic Show Control, as i understand Version 1, and when i was making my project in Designer i saw in tab "interfaces" Artnet and sACN. Is it mean that i can recieve Artnet if sACN signal and convert it to direct DMX output or not? If it is a true, could some body give manual how set it correctly?
Also i have read designer manual, it also says it able to recieve eDMX in interfaces,
Michaelv,Can you describe in detail what you're trying to accomplish?
Yes, I'm trying to use MSC as art-net - dmx converter, i use "q light controller plus" program to send art-net to range IP address , and as I understand it , MSC should receive art-net signal by ethernet and decode it to DMX out ( XLR ), where my devices connected.
try Network > select MSC > Protocols Tab > Edmx Pass-Through. Pick protocol and universe. Given the tool tip at the bottom, you may need to enable/disable this with a trigger.
Caveat: I'm seeing this in Designer 2.5.1. YMMV.