What's STILL in your tool box: CEM Airflow Calibration Tool

Hey, can anyone think of any situation where I would still need a CEM Airflow Calibration Tool in my tool box? I can really use the space...and I don't believe it has been used in over 10 years.

Actually, does anyone have a need (including the factory) for such tool? I'll part with it for the cost of shipping.

luke.delwiche over 13 years ago

Ha! I just ran across ours the other day, complete with calibrated plastic tubing from the local supplier.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
mmeskill over 13 years ago

I still have mine (from 1996) in my toolbox but I do not travel that much anymore. I would not think you would need to travel with these as they were primarily used on pre-1995 Sensor racks (pre-circuit breaker isolator and ribbon cable rack to rack jumpers). We have a few of them kicking around here in Middleton so I do not think we would need to get any more.

For those that do not know what we are talking about, see section for manuals on the CEM (Classic) page http://community.etcconnect.com/wikis/products/sensor-cem-classic.aspx

4263.Sensor CEM Airflow Calibration User Manual 1994.pdf

- Mike
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
mmeskill over 13 years ago in reply to luke.delwiche

@Luke “calibrated plastic tubing from the local supplier”

You are a funny man!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel