Moving Light to Follow Pre-Determined Path

everything:) what you wrote isn't translated on to how to program it on the cs, and it seems simple i know :(

in, out, wait times never seem to correspond. Cues or sequence? etc

Gotcha, let me give it a try.

Thanks!!

Hey Derek,

Here is a showfile showing how I would program what you described (I am running ColorSource v2.0.  I am only doing a simple Pan move in this demonstration.

If your problem was trying to get a mover to follow a straight line across the stage, then that is a whole different issue, and takes a lot of timing manipulations.

Sorry for the delay, while creating this I found a few bugs that needed logging before I could continue.

Thanks, ~Seth

Hey Derek,

Here is a showfile showing how I would program what you described (I am running ColorSource v2.0.  I am only doing a simple Pan move in this demonstration.

If your problem was trying to get a mover to follow a straight line across the stage, then that is a whole different issue, and takes a lot of timing manipulations.

Sorry for the delay, while creating this I found a few bugs that needed logging before I could continue.

Thanks, ~Seth

Yes -that was the whole problem. Thank You for trying!!!!

Ahh, moving along both axis is tricky.  I always try to hang my fixture in a position to allow that type move to occur only on the tilt axis.  It's by no means possible all the time, but if you can do a clean tilt sweep across the stage it will be far better.

One thing I have found to prevent the stutter stepping across the stage is to have the fade time slightly longer than the follow time (.1-.3 seconds).  This prevents the fixture from doing the start stop stutter.

Just a thought-maybe it could be an effect in the parameter library down the road, a straight line back and forth?