ETC CS20 - after pulling down (switching off) the playback fader and switching to manual mode the cue remains running

Hi there! 

I have a problem with CS20. 

I record a scene to a playback fader (doesn't matter which physical fader). 

Then I return all fixtures to home position. 

Then I go to playback mode and pull up the fader - the scenes run as should. 

Then I pull down the fader with playback - the fixtures dim out but moving heads continue to move in dark. 

I switch to channel mode, choose any fixture, move any fader up - but fader continues to function as a playback fader outputting the same data I recorded into the scene. 

Then I open fixtures parameters from the screen - I see that data is the same as I recorded into the scene. 

Then I once again press Home - the fixture returns to home position. 

Then I pull the fader down completely. 

Then I pull the fader up - only then the fixture starts to work in manual mode. 

Please tell me what to do to switch off the playback completely before going to manual mode.