Chauvet ColorStrip Issue

Brand new to the CS-20. While learning to record Cues, I set a few up with Chauvet ColorStrip and after playing a few cues, the ColorStrip behaves erratically. First it will not turn off. Then it will not function until I remove and re-patch it. Could this be DMX error or is a fixture issue? Or is it operator issues? Any history of this?

All of the other setup was going very well. Patching dimmers and devices worked seamlessly.

Parents

EpiloguePlayers over 5 years ago

I also have not terminated the DMX run. Just read about that. Although the run is fairly short, I will try termination to see if that helps. Thanks for the input.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

EpiloguePlayers over 5 years ago

I also have not terminated the DMX run. Just read about that. Although the run is fairly short, I will try termination to see if that helps. Thanks for the input.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Stuart Sampson over 5 years ago in reply to EpiloguePlayers

Oh, and another thing I gleaned from the manual is that the Master Slave used 3 pin XLR - the same as DMX. Could be potential for confusion. Some fixtures do master/slave on the same XLR and start sending data if they don’t see valid DMX, which can really foul things up. Make sure DMX is there before switching the unit on.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel