LED Fixture Not Responding in Cue

In addition to 24 channels of incandescent dimmers, we have a few Chauvet SlimPar H LED fixtures on a CS20. Two DMX runs through a splitter. The fixtures respond fine while programming and setting levels but do not work correctly when playing back cues. They will come on at maybe 10% but not to the programmed levels. Have termination on both DMX runs and have tried removing terminators with no change. Have tried removing one of the DMX runs. No change.

Am running the fixtures in 7 ch mode. Everything else seems to work fine, including color programing. Just not when playing back cues. Any troubleshooting suggestions?

Thanks in advance.

Parents

EpiloguePlayers over 4 years ago

All of the dimmers respond correctly in all cues.

I disconnected the DMX cable from all fixtures and powered down then plugged it all in again. It seemed to have fixed the problem. Also removed all termination. So now I will hold my breath, click my heels together three times and hope that it was just a "glitch" in one of the fixtures. Thank you for the suggestion.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

EpiloguePlayers over 4 years ago

All of the dimmers respond correctly in all cues.

I disconnected the DMX cable from all fixtures and powered down then plugged it all in again. It seemed to have fixed the problem. Also removed all termination. So now I will hold my breath, click my heels together three times and hope that it was just a "glitch" in one of the fixtures. Thank you for the suggestion.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data