I've ordered 4 fixtures like this : https://www.cameolight.com/fr/solutions/dj-musiciens/eclairage-statique/projecteurs-de-theatre/20479/ts-200-fc
These are Cameo TS 200 FC
In the latest library of my ColorSource (16.0.5) the two last dmx modes are 11 & 13 channels, but on the dmx table from the manufacturer it says 12 & 14 channels ( https://www.cameolight.com/fr/downloads/file/id/966404022 )
The mistakes are the same in both situation:
- channel 2 (dimmer fine) is missing, but there is a gap in the patch, so it's not a problem for next channels (but is it a normal behaviour ?).
- last channel is missing in the library. In both case on the manufacturer DMX table, the last channel (12 & 14) is the device setting, and the previous one is the color mode crossfade time (that don't seem useful). So I think there should be a gap here too.
I give tou an example for the 12 channels version:
The manufacturer table:
1 Dimmer / 2 Dimmer Fine / 3 Strobe / 4 hue / 5 hue fine / 6 Saturation / 7 Sat. fine / 8 Color temp / 9 Tint / 10 color mix / 11 Color Mode crossfade / 12 device settings
The console library:
1 Dimmer / 2 Gap (unpatched) / 3 Strobe / 4 hue / 5 hue fine / 6 Saturation / 7 Sat. fine / 8 Color temp / 9 Tint / 10 color mix / 11 device settings
So, is there a way to edit it by myself, or do I need to wait for an update ?
Thanks in advance !
At the time of writing ColorSource does not support 16 bit Intensity parameters, so the "Dimmer Fine" DMX slot is not used.
At the time of this post, library 16.0.5 was more than six months out…
The CS personality editor doesn't currently support editing of Lamp Commands, and unfortunately this fixture has several of those so you won't be able to edit the existing personalities. (You can create…