Hi All,
When I configure my fixtures (turn off color temperature (No Function) and define a color) and save this to a new file, these settings are there if I reload the file?
What could be wrong?
Thanks in advance....
Bob
Hi All,
When I configure my fixtures (turn off color temperature (No Function) and define a color) and save this to a new file, these settings are there if I reload the file?
What could be wrong?
Thanks in advance....
Bob
What I ment in previous post is after saving the fixture settings are NOT there after reloading the file. When I configure the fixtures and put then in a CUE it works fine (after starting the CUE). Could it be that configuring the fixtures, saving them and reloading them will NOT send the command s to the fixtures?
It sounds like you hadn't Recorded anything, so there's nothing to save.
Once you've set up your look on stage, it needs to be Recorded into a Cue or onto a Playback fader for later use.
It sounds like you hadn't Recorded anything, so there's nothing to save.
Once you've set up your look on stage, it needs to be Recorded into a Cue or onto a Playback fader for later use.
Hi Richard,
I was expected that also all data in a show was recorded when you save it to a file, even when you haven't recorded anything. Thanks for your answer, I now do understand WHY ;)
www.etcconnect.com