Sunstrip limited to 9 cells in magic sheet

Hi,

I've tried to make pixel grid with Sunstrip Active using a multicell device.
If my channel's device is121, I can add 121.1 thru 121.9 but impossible to have 121.10.
If i choose to increment channels with magic sheet tools 121.10 become 121.0 and if I try to enter 121.10 in target, it become 121.1
I tried in eos magic sheet, it works fine.
Any tips for me? (except converting sunstrip device to 10 channels)

Top Replies

Richard over 2 years ago +1

In Magic Sheets, the cell numbers are entered double-digit for fixtures that have 10 or more cells. So Channel 1, Cell#1 should be entered as "1.01", cell #10 as "1.10" Unfortunately there is currently…

krabe over 2 years ago
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Richard over 2 years ago

In Magic Sheets, the cell numbers are entered double-digit for fixtures that have 10 or more cells.

So Channel 1, Cell#1 should be entered as "1.01", cell #10 as "1.10"

Unfortunately there is currently a refresh limitation, it will not correctly display cell numbers above .9 until you exit Edit mode after setting the cell number.
At that point it will check the fixture type and update "1.1" to "1.10" if cell #10 exists.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel
krabe over 2 years ago in reply to Richard

I tried a few hours ago and It works with 1.01...1.02.... 1.10 become 1.1 and it control cell10 of my sunstrip.thanks for your reply
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel