independence key problem

These days i found a problem about the Congo independence key 7,8&9.

When I pushed on one of them then push any other keys on the board, the output of 7,8 or 9 will keep on full until I push the inpendence key again to release it.

I thought it's a bug of the Congo system.

Parents

pilou over 16 years ago

I have got the same problem with my congo JR
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Mat over 16 years ago in reply to pilou

You can set the independents to be either be a toggle button or not. When they are set to be toggle buttons they will stay at their recorded level until you press them again, like an on/off switch. The toggle button option is a check box at the bottom of the window where you record the channels to the independent. Browser>Setup>Independents>Independent 7-9. I you can also get to that window by holding Setup and pressing the independent key you want to edit.

-Mat
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
lytnupatl over 16 years ago in reply to Mat

I just ran into this issue yesterday. I was hoping to use Ind keys 7 and 8 for a qick lightning effect. Since the buttons would have to be momentary for the effect to work, I double checked that the toggle function was not selected.

The issue is just as previously described...press and hold Ind 7 then click Ind 8. This lock Ind 7 in the ON state until the 7 key is pushed again.

Anybody from ETC want to respond to this?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Nodice over 16 years ago in reply to Mat

Firstly thank you for you reply Mat.

Yet I have noticed the toggle function and I'm sure that I didn't use this.So it must be the problem of the system.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Nodice over 16 years ago in reply to Mat

Firstly thank you for you reply Mat.

Yet I have noticed the toggle function and I'm sure that I didn't use this.So it must be the problem of the system.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data