IMPORTANT SURVEY: Are you using ETCNet2/EDMX to distribute data in your system?

Venue:

Sorry, missed that.

SB

Thanks very much Steve, but as this is the CONGO forum I'm really looking for Congo systems with Net2 distribution. :-)

I hope you are well and that the above system is working well for you!

Thanks!

Sarah

Venue: Peepul Centre, Leicester UK
DMX Node used in input mode to allow for "HTP" merge with Unison.....

Congo Jr.

Broad Stage, Santa Monica

Net2 output nodes Universe 2&3

Net2 Sensor CEM+ Universe 1

Venue: SouthBrook Christian Church

Congo Jr.

4 EtcNet 2 nodes outputting Universe 2

Hello

I use EDMX to use WYSIWYG in LIVE mode with my Congo Jr.

I use my node Gawetay net3 in ETCNET2 mode like DMX in with Wysiwyg When I don't use an ETC board.

Pilou

Sorry, haven't been reading the forums lately. I did get a phone call, so hopefully my input's already in, but on the off-chance...

Yes, I'm using ETCNet2 nodes in both my spaces with my Congos, both 2-port PoE nodes and 4-port tabletop/rackmount A/C nodes. However, I do have a hybrid system in that there are 2 Net3 Gateways bracketing my Unison CMEi out of the mix, so that's different.