Neue Universen

Hallo,

wir haben jetzt 2 neue Universen integriert - alles soweit kein Problem nur das mir die beiden neuen Universen lediglich in der Output Liste,nicht aber in der Kreisliste angezeigt werden,auch wenn ich was patche.Dazu muß ich sagen das wir das Rename benutzen,ich kann dies aber nur in der Kreisliste tun.

Wie kann ich die Kreisliste für die neuen Universen sichtbar machen?

Gruß

Sabine Opitz

Theater Dortmund

Parents

0 Anders Ekvall over 12 years ago

Hallo Sabine,

I am not sure how you expect the new universes to appear in the Channe List. The Channel List just shows the channels, not outputs. The new universes should be visible in the Output Editor and in the Output List.

In the Channel List, you should be able to enter the new output addresses when you patch your channels. Do you mean that this isn't possible?

Anders
0 Anders Ekvall over 12 years ago in reply to Anders Ekvall

Sabine,

Have you downgraded the channel count of your Congo (normally it is at 3072)? This is done in System Settings. Make sure that you have enough channels visible.

Reply

0 Anders Ekvall over 12 years ago in reply to Anders Ekvall

Sabine,

Have you downgraded the channel count of your Congo (normally it is at 3072)? This is done in System Settings. Make sure that you have enough channels visible.

Children

0 Sabine Opitz over 12 years ago in reply to Anders Ekvall

Hallo Anders,

der zweite Tip war der richtige!!Es waren in den Systemeinstellungen nur 1024 statt 2048 Kreise eingetragen.

DANKE mal wieder für die schnelle Hilfe.

Liebe Grüße

Sabine

Theater Dortmund