Problems with V5-

Hi Daniel,

 - Saving Presets directly to Masters: You only record what you have selected (Intensity and Attributes). If you record to Playback you record everything regardless if selected or not.

I hope that helps....

Florian
 

Hi Daniel,

 - Saving Presets directly to Masters: You only record what you have selected (Intensity and Attributes). If you record to Playback you record everything regardless if selected or not.

I hope that helps....

Florian
 

Thank you for your feedback!

(When recording to a playback there are different cases... depending the selected play-setup...an then pop-up...)

Of course I am basically familiar with this .

Save content direct to masters:

It was the same with V4?

For what reason this difference (saving to a preset or saving to a preset via master)? 

Sometimes the manual / the issue is a little confusing...

Manual:

"For a Preset - all attributes are recorded, except those Masked by the
Global Mask. For a Sequence step only changed attributes are
recorded - just like in the sequence of the Main Playback*

You are welcome.

This behaviour has not change in V5 

The way I would explain this difference is, if you record a preset the desk assumes that you want to record the levels and change attributes (this depends on your settings). For the desk this is the standard way of recording presets.

You now have your look up in live and you have a nice pink on your RGB cyc. You realized that your Lighting Designer wants to use this colour again, you select your cyc channels and record them to a preset in a master you only record those channels. I prefer this to recording the channels into a group, because I find it easier to fetch Intensities from presets. ( # of preset [ON/FETCH] + [@ Level]).

Did I explain it ok?

Florian