• Date
    benberfield
  • Date
  • Replies 2 replies
  • Subscribers 65 subscribers
  • Views 6179 views
  • Users 0 members are here

Newbie with a question about networking

Just about the only boards I have worked with until now have been Expression and a few Strand I received the Congo Jr. about two weeks ago. My question is: Can I run both DMX and ETCNet at the same time? Say I wanted to use DMX1 and 2 as my first 2 universes, and wanted to add on the Net3 Gateway and use them for 3-6, would this work? I see a setting in the system preferences about the starting number for ETCNet, would I change this to 1025? Is there any documentation on this?

Thanks 

Parents

  • In your situation, the easiest is to leave the ETCNet2 Starting Address at 1, and patch your Gateway outputs to vPorts 3,4,5 & 6 using NCE.

    That way, the two ports on the Congo are universes 1 and 2, and the Gateway outputs are universes 3,4,5 & 6. 



    [edited by: Richard at 7:43 AM (GMT -6) on Fri, Mar 16 2007]
Reply

  • In your situation, the easiest is to leave the ETCNet2 Starting Address at 1, and patch your Gateway outputs to vPorts 3,4,5 & 6 using NCE.

    That way, the two ports on the Congo are universes 1 and 2, and the Gateway outputs are universes 3,4,5 & 6. 



    [edited by: Richard at 7:43 AM (GMT -6) on Fri, Mar 16 2007]
Children
No Data
Related

www.etcconnect.com