Information
Version: 5.0.0.9.0.42
Console Firmware: 1.0.0.0.0.009
IO Firmware: 1.2.0.9.0.1
Channels: 3072
Outputs: 2048
My Scenario: I have the play up and running. The console is in LIVE mode. I am up in the cats. I begin a channel/output (so I know what ouputs are in said channel) check. I proceed to use the Net3 RFR and go into the Patch portion of the 'controls.' I type in Channel 10 and see that nothing is patched into that channel. I then use the left 'scroll' wheel on the left side of the remote and scroll into channel 11. I then may scroll back to channel 9 (if I am lucky - see what follows). The remote seems to have locked up. No response from the keys, etc. I turn the remote off - wait a few - turn it back on - the remote does not connect. I climb down from the cats and see that the console is 'locked-up,' 'frozen,' 'messed-up' etc. On the 3 monitors is the gray slate background with CONGO across them...no response from the console. I reboot the board. I repeat the above scenario and have the same results. I have done this 4 times now.
Attached is my show file labeled Bugged. All y'all feel free to give it a shot (not that you have the time) - but curious to hear your results.
Thanks!
-Dana
