Hello, I would like to use it. 1. Connected phone to Congo – nothing 2. Looked in Browser > Remote Controls > .Remote Control List > Phone Remote is Enabled (checked) 3. Looked in Manual for chapter ‘Remote Control - Phone Remote’ – no word about any additional configuration. 4. Looked in Manual for chapter ‘Connector - Phone Remote’ There is connector shown with 9 pins, but RJ11 can have maximum of 6 pins ;-o It is written that pins 4,5 like ‘normal’ phone (Panasonic, made in Japan) has them on middle pins 3,4 in 6 pin RJ11 connector. What is correct then? Which is 1 pin in Your connector – not shown. Please help how to make it alive. Adam

Congo - Phone Remote

Hello,

I would like to use it.
1. Connected phone to Congo – nothing
2. Looked in Browser > Remote Controls > .Remote Control List > Phone Remote is Enabled (checked)
3. Looked in Manual for chapter ‘Remote Control - Phone Remote’ – no word about any additional configuration.
4. Looked in Manual for chapter ‘Connector - Phone Remote’

There is connector shown with 9 pins, but RJ11 can have maximum of 6 pins ;-o
It is written that pins 4,5 like ‘normal’ phone (Panasonic, made in Japan) has them on middle pins 3,4 in 6 pin RJ11 connector. What is correct then? Which is 1 pin in Your connector – not shown.

Please help how to make it alive.

Adam

Parents

0 JPALMERLD over 15 years ago

[Setup] tab over to "System"

Make sure that "Enable Remote Controls" box is checked. This is an overriding setting of the remote list. ie. both must be on.

Hope that helps.

The RJ11 has worked with standard North American cordless phones and cabling for me.

Personally, I love the phone remote. I have taken an old cordless phone and dedicated it for use with the Congo.

Take care,

John
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 pilou over 15 years ago in reply to JPALMERLD

Hello

Your phone must be a DECT model.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 kalendula over 15 years ago in reply to pilou

Thank You,

In software everything is enabled.I thought that DTMF (tone) technology will do...

How about cables, pins? Standard cable supported with DECT phone will do?

Thanks a lot.

Adam
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 kalendula over 15 years ago in reply to pilou

Thank You,

In software everything is enabled.I thought that DTMF (tone) technology will do...

How about cables, pins? Standard cable supported with DECT phone will do?

Thanks a lot.

Adam
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data