Congo with WYG on MacBook (bootcamp)

Have you download the Wysiwyg PC Driver for Congo and Congo Jr ? This little program will start, when you start wyg. You then have to tell it which logical net you want it to listen to. Make sure you have you congo set to the same one. Then wyg will listen to that one. you do not need to insert a net2 device into wyg. Wyg will always tell you that no device is connected, but it will work.

On a different note IPX is not supported by Vista.

Hope that helps....

Florian

There are two ways to control the Wysiwyg Visualiser from a Congo console or Congo Offline:

1. The Wysiwyg Driver mentioned by Florian.
   • This requires the IPX protocol to be installed in the host machine at both ends (Congo and Wyg), and therefore does not work under Windows Vista.
   • This supports the autoselect etc functions as well as basic visualisation.
2. ETCNet2 (EDMX)
   • This requires the TCP/IP protocol, and I have seen it work in Wyg R22 under Windows Vista.
   • This supports visualisation *only*, and requires that the EDMX protocol be enabled in Wyg and the lights patched to the correct EDMX channels.
   • This is not a Wyg driver as Wysiwyg supports EDMX natively, but it does need to be manually turned on and often patched.

I did notice that Wysiwyg R22 did not include "NICPicker", which is often required for EDMX reception when multiple network cards exist. This is included in ETC Network Configuration Editor, so this may help you.

I have not seen Wyg R23, so this may have already been rectified.

Up and running now - thanks for the help.

Turned off firewall in Vista

Installed NicPicker and assigned to correct network adapter

Tested with Net2utils - great to see some red values, and off we go 

Up and running now - thanks for the help.

Turned off firewall in Vista

Installed NicPicker and assigned to correct network adapter

Tested with Net2utils - great to see some red values, and off we go