hi to all...
i am new to the forum as new i am to the programming of the console Congo.
so plz be patient with me... now my questions....
1. when i record a preset for a sequence with dynamics why the dynamics keep running even when i am to the next preset of the sequence? (i have pressed the "auto stop dynamics" at congo setup page.)
2.i know how to create 1-2-3-4..... sequences and to load each one i want. i also know to create a chase sequence at to make a pause from WFA..... the question is when the next preset of the sequence is like "cut" time fade, the pause is NOT working. the sequense is NOT pausing to the step i used WFA and it keep running to the next steps.... i found out that the limit of the fade in-out must be over 0.5 seconds. this is bug or is just a limit? (Congo Ver 4.3.0)
3.is possible when i have a normal sequence that have 5 presets, to make No6 step to be a chase of 5 steps that i have create in a new chase sequense? and after that 5 steps to record again normal steps?
example : 1-2-3-4-5 ----> normal Go steps
6-7-8-9-10---->Chase steps
11-12-13-14-15---->normal steps
coz its a bit hard to have a MainPlayback and to create a Master with Chase sequence
****************************************************************************************************************
thanks for reading and i hope to get an answer...
coz the instruction manual is hard to read and understand when
english is not the natural language for me.... :/
