When you create absolutely new custom fixture in strobe address you can divide it to ranges. How Augmented knows which of them is strobe, close or open from 0 to 255? Where I can change these settings?
When you create absolutely new custom fixture in strobe address you can divide it to ranges. How Augmented knows which of them is strobe, close or open from 0 to 255? Where I can change these settings?
the solution was to label the ranges
the solution was to label the ranges
For those following this thread or searching for it later, here is the article with the labels required for Augment3d functionality: https://support.etcconnect.com/ETC/Consoles/Augment3d/Linking_Augment3d_Functionality_with_Eos_Fixture_Personalities
www.etcconnect.com