How to adjust augment3d model parameters to match actual devices

Both of those parameters can be edited in the fixture editor
https://www.etcconnect.com/webdocs/Controls/EosFamilyOnlineHelp/en-us/Default.htm#05_Patch/06_Fixture_Editor/About_the_Fixture_Editor.htm

You do have to save your changes and then go to live for the model to be affected. It won't refresh while in blind patch due to other concerns that could go awry for show data.

For Zoom, we reference the manufacturer's documentation for minimum and maximum degrees and the rest of that range is a linear calculation. So there could be an issue if the fixture is calculating the dmx range differently. You could fine tune with some specific ranges of that parameter but that would certainly be a lot of time to nail down.

Unfortunately Edge is a bit arbitrary and will be unlikely to get dead accurate. You could still mess with those percentage ranges for example maybe our "100%" edge is their "50%".

Both of those parameters can be edited in the fixture editor
https://www.etcconnect.com/webdocs/Controls/EosFamilyOnlineHelp/en-us/Default.htm#05_Patch/06_Fixture_Editor/About_the_Fixture_Editor.htm

You do have to save your changes and then go to live for the model to be affected. It won't refresh while in blind patch due to other concerns that could go awry for show data.

For Zoom, we reference the manufacturer's documentation for minimum and maximum degrees and the rest of that range is a linear calculation. So there could be an issue if the fixture is calculating the dmx range differently. You could fine tune with some specific ranges of that parameter but that would certainly be a lot of time to nail down.

Unfortunately Edge is a bit arbitrary and will be unlikely to get dead accurate. You could still mess with those percentage ranges for example maybe our "100%" edge is their "50%".

Thanks.  That's what I was looking for. 

The important part is down at the bottom:
       "To open the fixture editor, open the patch display and press the {Fixtures} softkey"

But that softkey isn't there and doesn't appear until you click on Patch, Attributes, Database, or Augment3d...   sneaky!

The softkey is there when you first get into patch and it will always come back as long as you don't have a channel selection and are not in the Protocols section.