Nomad RX UDP/OSC over loopback

Hi, I tried to control QLab and Nomad on the same laptop over the ethernet loopback (127.0.0.1). It is possible to control Qlab by sending OSC Data from Nomad, but it is not possible to do this in the other direction. QLab sends UDP and OSC over 127.0.0.1 (I tested it with wireshark) but Nomad does not receive anything.

0 Paul Toben over 8 years ago

I believe this is still not working. See this thread that you posted a long while back: http://community.etcconnect.com/etc_beta_sites/f/149/t/15361

Does it work when you give the computer a network IP address and send commands to that IP?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Druuka over 8 years ago

It should work if you put in the actual ip address of the computer in both applications. I have tested it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sstaub over 8 years ago in reply to Druuka

Thank you, i will try it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel