I just tried out some RTC events over the weekend & I failed.
1) Is there a way to turn On a submaster from an RTC event?
That sounds like a simple question, but On doesn't turn on a submaster, it toggles.
I set a RTC event to turn on my pre-show look while at dinner... but before I left, I threw up the sub.
The RTC event triggered & "On" turned off my submaster.
As I figure, I could either set 2 RCT events. 1 to turn off because that's absolute, followed by an On 1 minute later... Or write a submaster to turn on my sub.
but that all feels like I'm doing something wrong.
2) I set an RTC to clear my cuelist at the end of the night. Execute Cue 999/0.
It didn't. Well, it kind of did.
The levels of my last cue were left, but the values grey. but the Cue was cleared from the stack.
and yes, the console was outputting that data.
The only remedy I found was to create a cue that autofollowed to cue 0 and executed that. A macro executing cue 0 did not work.
I'm not sure if I did something wrong or that's a feature.
Thanks!