how to switch from live to blind over osc

Question

How can I switch the console display from live to blind and back over OSC?

ueliriegg · Accepted Answer

have you tried /eos/key/live and /eos/key/bilnd? i'm switching in my touchOSC layout but don't remember and can't look it up right now. 
 /eos/out/event/state will tell you if the console currently is in live or blind (0=Blind, 1=Live).

Louis · Answer

For LIVE i use: /eos/key/live For the Status LED: /eos/out/event/state Have a look at Value Range, From 0 to 1 For Blind i use: /eos/key/blind For the Status LED: /eos/out/event/state Have a look at Value Range, From 1 to 0 Both knobs are Push-Buttons. And i have "Send on Press" and "Send on Release" active. The Status indicator is the LED in TouchOSC This are the LIVE and BLIND Knobs simulate from Console. Not the Syntax for switch to an specific Q in Blind

how to switch from live to blind over osc

Top Replies