• Date
    MWeeks728
  • Date
  • Replies 3 replies
  • Subscribers 184 subscribers
  • Views 2265 views
  • Users 0 members are here

undo issue

I am not sure how to describe this issue but I'll try-

It seems that the undo function releases manual control of submaster channels that are set to any level below full. No mater where in the command history the manual change occurred. 

For example-

Sub 1 is at full it has Ch 1 @ full and Ch 2 at full

Ch 1 @ 0 enter

Ch 2 Full Full

Ch 3 @ Full enter

Ch 4 @ Full enter

undo enter

Ch 4 goes back to 0

ch 3 stays at full 

ch 2 stays manual at full

ch 1 goes to full and has been released from manual control

the redo function doesn't work.

 

Running 1.9.11

 

Parents

  • Thanks for reporting this, it is a defect and will be fixed.

    It only happens when the other manual levels that are not being undone are overrdiing HTP subs at a level that is lower than the HTP sub.  The undo causes these HTP subs to reassert themselves, so they then HTP with those manual levels.

Reply

  • Thanks for reporting this, it is a defect and will be fixed.

    It only happens when the other manual levels that are not being undone are overrdiing HTP subs at a level that is lower than the HTP sub.  The undo causes these HTP subs to reassert themselves, so they then HTP with those manual levels.

Children
Related

www.etcconnect.com