Finding subs

You could change the Playback Status Display format to show the first 10 pages - just activate Tab 2 and use [Format].

If you use [Sub][Sub] to open the Sub list, you will also see levels there.

Remember that if you know which sub is active, you can always use the command line to bring it out, e.g. [Sub][3][At][0][Sneak][Enter].

Luke

One of the problems is that the Playback Status Display shows sub pages 1 thru 10.  It doesn't follow the fader wing.  So it is possible to be on a page higher than 10, and the Playback Status won't show you the sub page you were on . (We use a 2x20 fader wing.)  I will have to try the Sub list to see if that helps- thanks for the idea. 

Brian

Remember also the [Sub][x][Thru][y][Home][Enter] command - it will set additive subs to 0 and inhibitive subs to Full.

and of course you could always use About on one of the channels you see active but don't know which sub they're coming from. it'll tell you which source is contributing the active channel's value.

Reply More luke.delwiche replied on Wed, Oct 17 2012 4:21 AM Verified by zawistow

Remember also the [Sub][x][Thru][y][Home][Enter] command - it will set additive subs to 0 and inhibitive subs to Full.

~It would be great to have access to SUB on the iRFR.

SBC said:

Reply More luke.delwiche replied on Wed, Oct 17 2012 4:21 AM Verified by zawistow

Remember also the [Sub][x][Thru][y][Home][Enter] command - it will set additive subs to 0 and inhibitive subs to Full.

 

~It would be great to have access to SUB on the iRFR.

Sub is listed under playback mode on my aRFR.