Macro: GO TO CUE

I have written cue 0.9 which contains work lights and has moving lights at full and in home positions. (Frankly the content of the cue should not matter).

Macro 807 has the folowing steps: Go_To_Cue_0.9 ENTER

When I execute the maco, the command line reads Go To Cue 0.

Why is this so?

0 ueliriegg over 12 years ago

i'm not in front of a console right now and i could be wrong. did you learn the macro or type it yourself? i think that "Go_To_Cue_0" is a reserved name and a fix command by itself. (i can configure one of the Gio user definable buttons to this fix command). i will experiment a bit tomorrow, but i think that it should be Go_To_Cue 0.9 ENTER (NB the missing underscore in front of the 0)

or of course it could simply be a bug...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 SBC over 12 years ago in reply to ueliriegg

I used learn. I also tried adding 1/ before the cue number. That did not help. Again the syntax of the Macro Display reads correctly.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Dan Duffy over 12 years ago in reply to SBC

When I try this in 1.9.11 (and 1.9.12) it works fine. I would try learning the macro again and see if it still happens. When the macvro is displayed, it should look like [Go_to_cue 0 . 9 ].
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel