Snapshots

i think for this task you would rather use a macro than a snapshot. you can also execute the macro with a cue.

ueli

Thanks i will gave that a try just geting started on the Eos been useing Srand 500i for most of my life its bit of a change.

welcome to the Eos world! and just keep asking whenever you run into questions.

cheers

As Ueli suggested a Macro is the easiest way. Its as simple as Sub 1 @ Full Enter or Sub 1 @ 0 Enter.

You can also use [Home] with subs if you want to write a Macro that  puts subs to their Home/Default position. So additive subs go to 0 and Inhib subs go to Full (meaning not doing anything)

HTH,

Snapshots of Faders do indeed record pending cues in any playback loaded to a fader, including the master pair. This is by design.

A workaround would be to release the cuelist off the master playback before you record the Snapshot, then load it back on afterwards. It will then not be affected when you replay the snapshot.

However, as mentioned above you are probably better off using a macro in this instance.

Snapshots of Faders do indeed record pending cues in any playback loaded to a fader, including the master pair. This is by design.

A workaround would be to release the cuelist off the master playback before you record the Snapshot, then load it back on afterwards. It will then not be affected when you replay the snapshot.

However, as mentioned above you are probably better off using a macro in this instance.