NCE download problem

hello to all ,

as part of my attempt's to connect EOS Offline to wysiwyg r29 (wich have not been going so well....) i have tried downloading the NCE package from www.etcconnect.com/downloads but every version i download show's an error when trying to open the ZIP file and running the NCE.exe (Damaged file ECT....)

i have tried running them on two diffrent PC's (both windows 7 64Bit) and came to the same result.

any idea's on where to get files wich work?

or any other suggestions on how to move forward from here?

thx in advance (:

BTW , not sure if this is the right forum for this question , if not accept my appoligies (:

speterson over 12 years ago

I would recommend calling ETC Technical Services. They can walk you through troubleshooting this issue easier on the phone that over the forums.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Richard over 12 years ago

Which link did you use to download?

I've just tried the download for the current release and it was fine here.

The only part of it that you may need is NICPicker.
- Note that NICPicker shows each physical network card several times under Windows Vista and Windows 7, so you will need to ensure you choose the version of your network card that has the right IP address.

Not sure if you've seen it already, go through all the steps on this Wiki page.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel