Query on "Query"

You can accomplish this same function by using the Group key. Example:

[Group][Preset][xx]  this will work with all record targets where Group can be replaced with Sub, Cue, FCBIP info etc.

Hope this helps!

David Smith 

Thanks Dave,

But I have tried that, and the problem is I just want to select the channels, I don't want to put them in their preset levels.

Yeah I've tried that too, thanks Idelwich.

I'm beginning to think this function doesn't work yet. 

Group Preset xx Enter should only select the channels, I will double check this on Monday.

Group Preset xx Enter will select the channels associated with that Preset--It will also put those channels into their recorded IFCB value.

Group Preset xx At 0 Enter will select the channels and only assign the channels a value of zero. It will not put the channels attached to the specified preset into the recorded IFCB state.

Josh Selander

Field Service Enginer

ETC-West
 

Thx Josh,

But I should have been more specific...

I am trying to SELECT only, not modify the values of the channels captured in the preset.  Eg:  My designer wants me to grab all the fixtures in Preset 20 and raise their levels 10%, or change their colors to frame 1, etc...

The way I read the manual, Query should do what I want.  But it doesn't.

Mike,

 I was doing this all day today.

Push Query then look at the softkeys, Push softkey "Can Be" (bottom right of right screen) and then the Preset/Pallete and then Enter.  This will select any channels that are recorded into that Preset/Pallete and Select them ONLY, no values.

If you want to grab everything that is onstage in a specific Preset/Palette, then Push Query and then the Preset/palette and then enter.  Again, only those channels will be selected, no values will turn to Manual.
 

Mike,

 I was doing this all day today.

Push Query then look at the softkeys, Push softkey "Can Be" (bottom right of right screen) and then the Preset/Pallete and then Enter.  This will select any channels that are recorded into that Preset/Pallete and Select them ONLY, no values.

If you want to grab everything that is onstage in a specific Preset/Palette, then Push Query and then the Preset/palette and then enter.  Again, only those channels will be selected, no values will turn to Manual.