Programing Movers & LEDS on Fader Wings

Hey all,

I am having some trouble programming some simple LED fixtures as well as some Mac 250 Entour's on the ETC Ion console. I am wanting to program different color and movement looks to sbumasters and then just run them off the fader wing.

When doing so I can get the looks I want but when I use the fader to control the look it must fade through other colors/positions to get to the final result. The same occurs when fading out of the fader. Is there a way to program intensity parameters, color parameters, position, etc separately to where this wouldn't happen much like on a Road Hog console. I am new to programming on the ETC ION console and am having trouble.

Thanks for the help.

Parents

sk8rs_dad over 11 years ago

Change your subs from Proportional to Intensity Master. (Sub x {Fader}[Enter]). The {Fader} softkey will toggle between the 2 values.

Hitting the bump button or nudging the fader will set all the NPs to their stored value and the fader will control the intensity.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
SBC over 11 years ago in reply to sk8rs_dad

But the bump (flash) button does not work in this mode.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

SBC over 11 years ago in reply to sk8rs_dad

But the bump (flash) button does not work in this mode.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

jkpitzer over 11 years ago in reply to SBC

Make sure that the home value on each is set to 0. The default is 100. When you move a sub, it starts from the assumption that all parameters start at the home value.

If you need to change it, put all values at 0 and then record them as a preset. Then, in the show settings, make your default home value be that preset number.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel