Mark Time

Hi Paul,

in the moment there is no way to set an individually mark time by cue or channel or attribute, hope that will be possible in future. But you can set a generally automark time in setup, which is very helpfully.

sstaub

Thanks sstaub but as I pointed out in my post I am aware of the current methods of using a mark but was hoping for a more general discussion about development of mark time.

I'm aware that there will be a change regarding mark time. Right now it follows the timing of cue part 1, but at some point in the future it will follow the timing of the part containing the marking parameters.

You can put a mark on a different part and the time will come from the part with the mark on it. I do this all the time using Part 20.

We did have a discussion a while back about adding a cue level mark time and I think that is still on the radar.

Cheers

Dan

You can put a mark on a different part and the time will come from the part with the mark on it. I do this all the time using Part 20.

We did have a discussion a while back about adding a cue level mark time and I think that is still on the radar.

Cheers

Dan

Ah sorry, what I said is regarding automark.