• Date
    jrgoss
  • Date
  • Replies 1 reply
  • Subscribers 187 subscribers
  • Views 1676 views
  • Users 0 members are here

Updating to 2.1

I updated a couple Ion RPU & Gio desk setups, & I noticed the following odd behavior: Setup is a ION RPU Primary & Gio backup. I exit out of the software on the Ion Primary, run the software update (Gio has taken control of the rig) & after installing & rebooting I have the RPU take control from the Gio. It pulls in the show file, but does not recall the current Live or Parked output when the RPU Primary takes control & thus everything goes dark. Same behavior happened in 3 different studios.
Parents

  • This will be because of a version mismatch.

    You can not sync two desks of different versions.

    The better way of doing this would be.

    • Break sync (Gio in control)
    • Install update on RPU, reboot
    • Load show and goto cue
    • Install update on RPU, reboot
    • Sync GIO and RPU

    N.B. Parked data is not saved into a show file.

Reply

  • This will be because of a version mismatch.

    You can not sync two desks of different versions.

    The better way of doing this would be.

    • Break sync (Gio in control)
    • Install update on RPU, reboot
    • Load show and goto cue
    • Install update on RPU, reboot
    • Sync GIO and RPU

    N.B. Parked data is not saved into a show file.

Children
No Data
Related

www.etcconnect.com