ION no fog

Have you patched the fogger as a fogger? If so, the Ion probably isn't looking at it's output as an intensity (which is what the wheel affects, I think) but as another non-intensity parameter like image or beam, maybe, depending on the profile. See how the encoders are labelled, when you tag the various parameters.

Another thing to maybe look at - if you're running straight DMX, with no profile loaded - is how many channels the fogger uses - it could be the first channel is something like fan speed, not output. Not familiar with your particular fogger.

All that being said, I'm having similar difficulties getting my DMX-ready hazer to run with its profile on our Ion - I know it's very likely operator error, as it works fine on our other console. I just haven't asked it to haze the way it wants ...yet. But those would be the first few things I'd try.

Jonathan

Tried dimmer, fog and haze - all generic. It's a single channel fogger - Ultratec Stage Fogger.

According to the UltraTec manual, it lists three DMX channels - the first is output, the second is LSG (external chiller unit maybe?), and the third is "Optional Air"  (Also ?) - but I don't see any way to plug these units in... Unrevised manual? My misinterpretation? Either way, try sending values to those two channels, and see if that does anything.

The back of the unit seems to have a "Valid DMX"  LED - with the remote unplugged but DMX in, you should see this on, solid or flashing quickly, when the unit is ready to go, slowly when it's heating. As Glenn suggested, maybe try turning it off and on any time after resetting the DMX addressing. If the unit's seeing valid data, it should be working as you have it.

According to the UltraTec manual, it lists three DMX channels - the first is output, the second is LSG (external chiller unit maybe?), and the third is "Optional Air"  (Also ?) - but I don't see any way to plug these units in... Unrevised manual? My misinterpretation? Either way, try sending values to those two channels, and see if that does anything.

The back of the unit seems to have a "Valid DMX"  LED - with the remote unplugged but DMX in, you should see this on, solid or flashing quickly, when the unit is ready to go, slowly when it's heating. As Glenn suggested, maybe try turning it off and on any time after resetting the DMX addressing. If the unit's seeing valid data, it should be working as you have it.

Its not the LSG chiller. Its only the Stage Fogger.

So just tried my Smart Fade and it works. Something going on with the ION.

Have you done an About on the channel once the fogger is patched and you bring its level up? Is the channel parked off by accident? Is there a curve mistakenly on the channel? Did you try the Smartfade from the same location as the Ion using exactly the same cables, etc?

Used dmx tester & 0-255 is going out but ION refresh rate is 25 & SF is 37. Maybe thats it. Not sure if I want to change that on my IIN for what it will do to other fixtures. Yes using same DMX cable.

Add also tried a few channels plus looked at about & only shows Manual, value,abs & dmx values when using channel.

Rate in ION was set at medium. I changed it to fast & fogger now works but don't know what will happen to my Chauvet led fixtures in the show. Chauvet is different with their rates & they don't seem to want to fix em.