Gio moving lights issue.

and you are sure that the personality and mode you chose in Patch matches the settings of the fixture? btw: do bring up a light's intensity just use the wheel (right hand wheel that is) or the At button, instead of Intensity in the command line. that would work as well, but you're way faster with the other methods.

Yes. I have the board set up right, patch and personality does match.
I used the wheel to set the light level then recorded it in the cue list, the system is running on a SMPTE time code off a video server.

what does About > Patch say? does the console claim to be outputting a value to e.g. the Intens address, that according to the manual should make the light open up?

it's not a intensity problem, it's a focus palette issue.
The light works as it should, just when cue 100 has the light at point A @50% and cue 101 moves the light to point B @ 100% in 4 seconds, a 4 foot move, it has a small curve in the movement. But when the same light goes to cue 102 @100 in 2 seconds to point C, a 40 foot move, it's strait without a curve. The move should not move the pan at all, just tilt. I have the lights turned so that there is no pan. The color wheel works fine as well as the gobo wheel. it's not a intensity problem, it's a focus palette issue.

it's not a intensity problem, it's a focus palette issue.
The light works as it should, just when cue 100 has the light at point A @50% and cue 101 moves the light to point B @ 100% in 4 seconds, a 4 foot move, it has a small curve in the movement. But when the same light goes to cue 102 @100 in 2 seconds to point C, a 40 foot move, it's strait without a curve. The move should not move the pan at all, just tilt. I have the lights turned so that there is no pan. The color wheel works fine as well as the gobo wheel. it's not a intensity problem, it's a focus palette issue.