• Date
    usesafesets
  • Date
  • Replies 2 replies
  • Subscribers 182 subscribers
  • Views 2675 views
  • Users 0 members are here

Flasher

So I am using an ION and today I have developed a flashing issue. There are no cues recorded in the desk. Several times during our work time today every conventional unit in the plot flashed on to full and then went off. The only solution that I could find was to exit out of ION to the shell and then perform a deep clean.

 

Anyone else experience this? Any ideas on what it may be?  

Parents
  • You're not alone. I've had the same thing happen on our Ion. It seems to happen immediately after power up, and a deep clear fixes it. I was thinking it might be some crud left after changing the patch since after a deep clear I didn't see it again. I'm not looking forward to this month's electricity bill since I'm sure we set an all-time peak bouncing all the lights to full.
Reply
  • You're not alone. I've had the same thing happen on our Ion. It seems to happen immediately after power up, and a deep clear fixes it. I was thinking it might be some crud left after changing the patch since after a deep clear I didn't see it again. I'm not looking forward to this month's electricity bill since I'm sure we set an all-time peak bouncing all the lights to full.
Children
Related

www.etcconnect.com