Viewing NIP output

Is there a way to view nip output (or all output)? I'm applying curves to nips and that's fine but programming off line it's hard to tell what I've created as the live display doesn't obey the curve info. thanks.

0 ueliriegg over 10 years ago

About is your friend ;) (you need to be in Offline w/ Viz mode rather than Offline though
just out of curiosity: how are you applying curves to NIPs? cue part curves are the only way i know of...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 daz6666 over 10 years ago in reply to ueliriegg

About was the answer I needed. Thanks!
Yes you can only apply a curve to a channel, cue or part of a cue, but if that part (not part 1) only contains the pan of the light etc. that is all that uses the curve. chan 1 pan record cue 2 part 2, cue 2 part 2 curve 2.
Thanks again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel