Issue - Power switch per lamp control as fixture part - All switches off on return from setup shell

Hi everyone,

we've set up our fixtures with part 2 controlling the power switch (Lamp Control).

Every time we go from shell into console mode, all switches are set back to off.

Is there any solution to hold them in "Power on" Lamp Control status?

Parking them does not work on control channels. And we don't want to separate them from the lamp to their own fixtures.

Thanks a lot

Leandros

0 corey cascio over 10 years ago

If you park the parameter, it will stay in its state thru a visit to shell.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ueliriegg over 10 years ago in reply to corey cascio

but then you can't have them as lamp control parameters, since those can't be parked...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 corey cascio over 10 years ago in reply to ueliriegg

But u can make this parameter Intens Mech, and not Lamp Control and Park then the Intens Mech Parameter
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ueliriegg over 10 years ago in reply to corey cascio

of course, or you could make it Relay or something, but this doesn't change the fact that currently i can't have my HMI ignition work the same way as my movers'...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel