Well this might be a SmartBar issue as I'm trying to re-address some new SB4 & SB6 bars from a new Element. Upgraded the Element to 2.3.1. The stuff had been in boxes for several months. Ran Concert, got the LEDs - well the ones that were plugged in[:)] Got ladder. Set mode and address just fine. SBs reported what they were but would not let me change anything. They also claimed an address of ~64555 (didn't record it) Ran Eos and looked in device list and nothing showed at all. Straight control is good. I won't be on site for a while, and physical access to the bars is a bit of a pain. So an RDM, software solution would be best.

RDM issues?

Well this might be a SmartBar issue as I'm trying to re-address some new SB4 & SB6 bars from a new Element.

Upgraded the Element to 2.3.1. The stuff had been in boxes for several months.
Ran Concert, got the LEDs - well the ones that were plugged in[:)] Got ladder. Set mode and address just fine.
SBs reported what they were but would not let me change anything. They also claimed an address of ~64555 (didn't record it)
Ran Eos and looked in device list and nothing showed at all.
Straight control is good.

I won't be on site for a while, and physical access to the bars is a bit of a pain. So an RDM, software solution would be best.