Chauvet Ovation E910 FC profile

I'm running 2.3.2, and can't upgrade to 2.3.3 for a few weeks.

I'm looking to demo the Chauvet Ovation E910 FC (Full Colour) LED ellipsoidal unit in the near future. (it is just being released next week or so)

as far as I can tell, there is NOT a profile for this unit in 2.3.2 (there are a bunch of WW profiles).

Looking through the 2.3.3 library documentation, as far as I can tell, there is not yet a profile for the FC unit. Is this correct, or am I just missing it?

Other than running up the DMX addresses to full, any other way of easily demo'ing a unit without a profile?

Thanks

Andrew

sk8rs_dad over 9 years ago

Find a profile that is close, copy it and tweak it to suit. You won't get colour calibration but it should allow you to use it and exercise some of the built in features.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
saranow over 9 years ago

Did you want a profile created for 2.3.3 for the future?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Andrew Riter over 9 years ago in reply to saranow

only if I buy them....

I suspect that you'll make one up eventually. I was just confirming that I hadn't missed an existing one (being 1 upgrade behind).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Jeff Toussieng over 9 years ago in reply to saranow

I would. Does this work:
http://www.chauvetprofessional.com/wp-content/uploads/2015/06/Ovation_E-910FC_QRG_Rev3_ML4_WO.pdf
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
saranow over 9 years ago in reply to Jeff Toussieng

It does!
Your request has been submitted. Do you have a deadline?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel