• State Not Answered
  • Date
    kirkdkeen
  • Date
  • Replies 4 replies
  • Subscribers 186 subscribers
  • Views 4715 views
  • Users 0 members are here

ColorSource Fixtures and RDM

Hello everyone --

We have a bunch of brand new ColorSource fixtures (both profiles and washes) and we have this issue where when RDM is turned on in the ION and we cycle the power to the fixtures a random number of them will re-address themselves a couple of DMX addresses above or below where we set them. When we turn RDM off we don't get this problem. Is there a way to fix this?

Running newest software, all lines are terminated, going thru NET3 nodes, fixtures were addressed by hand, not via RDM.

Thank you!

K2

Parents
  • 0
    I saw this issue when i first installed new fixtures, but it went away after I locked the displays on the units. I haven't changed RDM settings since then. I never got back to troubleshooting.. It was id #300446257 when I called in to ETC, but I don't know if that will have anything useful, because as mentioned I never got deep into the troubleshooting!
Reply
  • 0
    I saw this issue when i first installed new fixtures, but it went away after I locked the displays on the units. I haven't changed RDM settings since then. I never got back to troubleshooting.. It was id #300446257 when I called in to ETC, but I don't know if that will have anything useful, because as mentioned I never got deep into the troubleshooting!
Children
Related

www.etcconnect.com