Higher FaderPages on External Fader Wings

Hi. I saw you posted on FB about this as well, and a workaround was suggested. In 2.4, the motorized fader wing will support Fader Page + any number from 1 -100 to change pages. We will implement this on the universal fader wing in 2.5....

Thanks much!
anne

Hi Anne, Thanks
It must have been someone else on FB, any chance you can pass on the workaround?

The motorised wing sure does look snazzy ;)
Though we have only just bought a universal Fader wing, so guess we're stuck with 30 pages.

someone posted this in the FB group "ETC Eos Family Console Programmers"
"But I created a bit of a work around that got the result. I recorded the key strokes into a macro to change to one of the lower page numbers. Edited the macro and hit a channel tombstone and deleted the CHAN section. The trouble with just typing in the number was that it would only take the first number and then type the second number in the cmd line. So the channel tombstone creates the double digit number that is a single syntax unit."

someone posted this in the FB group "ETC Eos Family Console Programmers"
"But I created a bit of a work around that got the result. I recorded the key strokes into a macro to change to one of the lower page numbers. Edited the macro and hit a channel tombstone and deleted the CHAN section. The trouble with just typing in the number was that it would only take the first number and then type the second number in the cmd line. So the channel tombstone creates the double digit number that is a single syntax unit."