Element magic Sheets

I'm new to Magic Sheets - most of it I'm figuring out, if slowly. Set up is Element with OS 2.3, 15" Dell monitor (VGA) - monitor 1, 21"HP monitor - monitor 2. Magic Sheets on monitor 2, everything else on monitor 1. Below the Magic Sheets there are some tombstones (41 through 60). Can I make them go away? Would like the Magic Sheet to be full screen if possible. Thanks. Sorry if this is a bit of a dumb question.

cdiamondz over 8 years ago

Couple pictures? Might it be possible that you're running in split screen?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jpgagnon over 8 years ago

I assume you are talking about the Submaster/Channel grid that lives that the bottom of the primary display? You can change which monitor is the Primary Display in the Shell-Monitor Arrangement settings. That will move the grid to the other monitor.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
tberry24112 over 8 years ago in reply to cdiamondz

here are two screen shots. Hope this works. The upper picture is Monitor 1 (Dell), lower is 2 (HP). In setup the Dell is listed as primary monitor. It's not a big thing, but would like to get as much of the Magic Sheet visible as I can while still being able to read the labels. Thanks.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
ueliriegg over 8 years ago in reply to tberry24112

the HP monitor seems to have the wrong screen resolution. use Exit to get to the shell, there you click Settings, and in General you can find Monitor arrangement. click Identify, this will show a big number on both displays so you know which is which. in the monitor arrangement display click the respective box and then change the display resolution to the one your monitor has according to its datasheet.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel