problem with a fixture profile - MDG ATMe Haze

i agree that probably the second DMX address should be controlled by the intensity wheel.

but i don't see the problem with address 2 and 3. the way you describe in your post is the way in the manual and is also what the personality does. the current version of the personality was released in August 2016. could it be that you were on an older software or had used an old showfile that had already patched an old version of the personality?

i agree that probably the second DMX address should be controlled by the intensity wheel.

but i don't see the problem with address 2 and 3. the way you describe in your post is the way in the manual and is also what the personality does. the current version of the personality was released in August 2016. could it be that you were on an older software or had used an old showfile that had already patched an old version of the personality?

you are right. the fixture is correct.
What was the false thing than...
i will check as soon as i'm in the theater again.

We use that same MDG Hazer. If I recall correctly, the output is not variable (governed by CO2 pressure set on the regulator). You have two channels, HEAT and Haze On/Off, both should be set to a SNAP value. I created a generic profile and included a "dummy" intensity parameter so that I could see on my Magic Sheet if the Hazer was on or off. I could share that info with you if you're interested!