• Date
    Sean Evans
  • Date
  • Replies 2 replies
  • Subscribers 185 subscribers
  • Views 2306 views
  • Users 0 members are here

RDM and ColorSource Relay/Spot

I just upgraded the software on our ColorSource Wireless Relays (or attempted to). 4 of the 5 are still showing 1.0p0.0ga-35, 3.0p0.0ga-5 for "Software Version Label" while the 5th shows 1.1.0.9.0.11, 3.3.0.9.0.593 (the 5th was the first one I attempted to update.) All were updated from the same flash drive. I reattempted the installation on each of the other 4.

RDM discovery does (eventually) find all 8 of the ColorSource Spots (but does not seem to come up with them as Deep Blue), which are connected to the 4th relay, but only 1 of the 15 Elation SixPar 300s is discovered. (those are on different relays than the ColorSource Spots). 

If anyone has any suggestions of things to try, I'd love to hear them.

Parents
  • Do you see different behavior on the Elation SixPar fixtures if they are connected directly to the back of the Ion? A quick test with a single fixture direct to the back of the console would be useful diagnostically. (Console I/O card has to be running firmware version 1.4.1 or higher -- you can check this in Diagnostics (Tab 99) on the left hand side of the screen towards the middle). You could also run them into a Net3 DMX/RDM gateway if that's easier.
    Are the fixtures terminated at the end of the line?
Reply
  • Do you see different behavior on the Elation SixPar fixtures if they are connected directly to the back of the Ion? A quick test with a single fixture direct to the back of the console would be useful diagnostically. (Console I/O card has to be running firmware version 1.4.1 or higher -- you can check this in Diagnostics (Tab 99) on the left hand side of the screen towards the middle). You could also run them into a Net3 DMX/RDM gateway if that's easier.
    Are the fixtures terminated at the end of the line?
Children
No Data
Related

www.etcconnect.com