• State Not Answered
  • Date
    brinkkl2000
  • Date
  • Replies 5 replies
  • Subscribers 186 subscribers
  • Views 3863 views
  • Users 0 members are here

Removing focus pallet from fixtures

If I built a cue stack, and in cue 3 I programmed in focus palette 1, and later want to take it out, how is that done? Even if I didn't record the cue yet, I know I can use sneak or undo to take it out, but is there another way. Similar to removing an effect, I can use [@][effect][enter] ( if I remember right).

Parents
  • 0
    well, the question is where else do you want pan tilt to move? if they are somewhere else in cue 2 and in cue 3 you want them to stay, in cue 3 you say Chan 1 @ Enter. if you do it in Live you will have to Update afterwards, if you do it in Blind then you're set.
    remember that depending on Cue Only or Tracking mode this can also impact the cues after cue 3.
Reply
  • 0
    well, the question is where else do you want pan tilt to move? if they are somewhere else in cue 2 and in cue 3 you want them to stay, in cue 3 you say Chan 1 @ Enter. if you do it in Live you will have to Update afterwards, if you do it in Blind then you're set.
    remember that depending on Cue Only or Tracking mode this can also impact the cues after cue 3.
Children
No Data
Related

www.etcconnect.com