Hello,
I created new fixture to control Camera XYZ Position in visualiser.
I chose 'X position' parameter for controlling camera X position and the same for YZ camera
positions.
Then in Live if I select the fixture, I can see 'X position' parameter on one Form page, the 'Y
and Z positions" parameters on second Form page. While I would like to position my camera all the
time I need to switch between three pages, because on third there is zoom placed.
My needs:
1. To have XYZ positions on one Form page
2. To have on one Form page XYZ position parameters, and zoom parameter - then it will be only
one page to control Camera Form parameters and it will be fast.
3. Is it possible to set these parameters under Custom Encoder button. I tried to find it in
manual, but found only introduction.
For now it is much quickest to control my camera from SmartFadeML ;-)
Adam