I'm having a problem getting Nomad to connect to Capture - running on the same macbook. I have checked both are using same ip address, protocols are setup and interfaces listed in patch view.. The universe just doesn't appear in Capture..
Any suggestions would be most appreciated
Many thanks
is your macbook connected to anything at all? there was a thing that a mac needs to have any network connection so its network services are running. only then can you use network stuff even if it's only inside your computer
is your macbook connected to anything at all? there was a thing that a mac needs to have any network connection so its network services are running. only then can you use network stuff even if it's only inside your computer
This maybe as simple as the firewall settings on the mac, as even though both things are on your machine, its being treated as going onto a real network and so capture is going to need to be allowed to respond to incoming data.
Whilst you shouldn't run with your firewall off, you can go into system preferences on the mac and security and turn it off temporarily to see if that fixes the issue. (Write a big post it note to yourself to turn it back on again as its easy to forget).
It it does fix the issue then there is a proper way of just allowing the traffic to capture to flow.
Do you have any real lights connected on net3 or artnet, so do you know if nomads is actually sending data out on the network as there a few places you need to tell it to do it.
