I'm not sure if I went about doing this the right way, but I created an effect and was curious to see if I could record it to a submaster. After numerous attempts, I figured I wasn't doing to figure it out on my own. Any ieas? -Thanks
Hi there.... effects on subs are not yet supported. But they will be in an upcoming software release. And to store them, you'll do it much as you store data to subs now.
When people first started discussing this, there was a lot of talk about using a second cue list with an intensity fader as a workaround. In my mind, I had envisioned a step-based effect, rewritten as a series of looped cues. I have since been enlightened to understand that all it takes a single cue on a fader with any effect attached to it. I haven't needed to do this yet but it is a simpler way of looking at it.
When people first started discussing this, there was a lot of talk about using a second cue list with an intensity fader as a workaround. In my mind, I had envisioned a step-based effect, rewritten as a series of looped cues. I have since been enlightened to understand that all it takes a single cue on a fader with any effect attached to it. I haven't needed to do this yet but it is a simpler way of looking at it.
Will the submaster effects be only the effect with the need to select the channels to activate, or will it be able to have the channels recorded into the sub as well (kind of like using the bump button for a NP and the fader for the intensity such on an IQ)? My preference is to have the channels recorded into the sub as well, otherwise I might as well just grab the channels and the desired effect off the direct selects.
